Seasonal clean and tune-up
Fault found and fixed on-site
Sized, supplied and installed
Deep clean for mould and odours
Gas heater safety check
Move an existing system
Damage reports for claims
Pricing for every service
One flat rate per visit for repairs and servicing, any brand. Returning customers save more.
ACT · Canberra
NSW · Sydney
QLD · Brisbane
SA · Adelaide
VIC · Melbourne
WA · Perth
Every state we cover, with local services and the best time to book in each.
Breezair specialists
Breezair evaporative coolers sit on rooftops right across the hot, dry parts of Australia, and we look after the whole range. Our licensed technicians service, clean, repair and install Breezair evaporative coolers, with a fixed price agreed before any work starts.
Every Breezair cooler
Whether it’s a new Supercool on a family home or a twenty-year-old unit that has never been opened, our technicians know how Breezair coolers are built and what tends to go wrong with them. This is the Breezair work we do most.
Rooftop ducted evaporative cooling for the whole house, including the Supercool EXS and EXQ series.
Pads cleaned, tank flushed, pump and drain valve tested, so the cooler is ready before the first hot day.
Chillcel pads that are scaled up, crumbling or smelly replaced to bring back airflow and cooling.
Repairing water pumps, solenoid valves, drain valves and leaking tanks before they damage the roof.
Draining the tank, isolating the water and covering the cooler so it isn't dropping cold air into the house.
Fault-finding MagIQtouch and older Breezair wall controllers and remotes, including service codes that won't clear.
Breezair coolers that are no longer made. We repair them where it's worth it and tell you honestly when it isn't.
Replacing an old cooler with a new Breezair on the existing ducts, or a full new installation.
Common Breezair faults
Most Breezair problems start small: a service code on the controller, air that isn’t as cold as last year, water running off the roof. These are the faults we fix most often, and what usually causes them.
A service code, such as Service 2, means the cooler has detected a fault and stopped. We read the code, find the cause and fix it so it doesn’t come straight back.
If the air isn’t cold, the pads usually aren’t getting wet. A failed pump, a blocked water line or scaled-up pads are the common causes, and all are fixable.
Water running down the roof or a tank that never stops filling points to a stuck drain valve, a faulty solenoid or a cracked tank. We find it and fix it.
Rumbling or squealing means worn bearings or a tired motor. A musty smell on start-up means stale water or dirty pads, which a proper clean sorts out.
When to service
The best time for a Breezair evaporative cooler service is spring, a few weeks before the first hot spell. It catches a seized pump or scaled-up pads before the heatwave, when everyone is calling at once. In autumn, a shutdown service drains and covers the cooler for winter.
Either way you get a written report at the end, so you know the condition of the pads, pump and motor.
Get your Breezair evaporative cooler running clean and cold before the first hot week.
Drain, clean and cover the cooler so it's protected over winter and ready for next season.
Answers to the questions Breezair owners ask us most, from how often to service your cooler to what a service code means. Can’t see yours? Call us on 1300 730 896.
Straight from our experts
Licensed, insured and local
Get the clarity you need
Once a year, ideally in spring before you start using it. In areas with hard water or a lot of dust, the pads may need attention more often.
Keeping the system maintained is part of looking after your warranty. Every visit comes with a written report, so keep it with your purchase paperwork in case you ever need to make a claim.
A service code means the cooler has found a fault and stopped to protect itself. Turn it off at the controller, wait a few minutes and try again. If the code returns, book a check instead of resetting it over and over.
Usually the pads aren’t getting wet, because of a failed pump, a blocked water line or heavy scale. Evaporative cooling also needs some windows or doors open, and it works less well on humid days.
About an hour for most homes. It takes longer if the pads need replacing or the unit hasn’t been serviced for several years.
Current Supercool EXS and EXQ coolers and older Breezair models, along with MagIQtouch and earlier wall controllers.
If the cooler is under about ten years old and the fault is minor, a repair is usually worth it. For older coolers facing a big repair, we’ll give you both prices so you can decide.
No. All Good is an independent heating and cooling company and isn’t affiliated with Breezair. Our licensed technicians service, repair and install Breezair evaporative coolers across the range.
Tell us what’s happening with your Breezair cooler and we’ll help you work out the right next step. From repairs and servicing to maintenance and new Breezair installations, our licensed technicians are ready to help.
Takes about a minute. Tell us about your system and what you need.
We ring to lock in a time that suits you. No automated booking maze.
Your technician cleans, tests and tunes the system, then leaves a service report.
Fast, friendly and obligation-free. Tell us a little about your system and a local technician will be in touch.